~~NOTOC~~

<WRAP noprint>

> User manual #@IC_HTML@# > Settings > Project settings

</WRAP>

====== Tolerance tables ======

----

The general tolerance tables valid for the project can be selected on the //Tolerance tables// tab of the //Project settings// menu. Click on

  * **Apply,** at the bottom of the window to save the changes without closing the window,

  * on **OK,** to save the changes and close the window or

  * on **Cancel,** to discard the changes.
 
The settings are saved with the project.

> **Note** Your CAQ system provider or administrator may be able to prevent you from changing some settings under certain circumstances. Please contact them if an incorrectly set option interrupts your workflow.

The default values of the settings can be specified in the parameter file "Settings", see Administrator Manual #@IC_HTML@# > Configuration and Import > [[en:infra-convert:dev:settings|Parameter File "Settings"]].

\\ 

<WRAP noprint>
<WRAP group>
<WRAP column 35%>
//**__Content__**//

 • [[en:infra-convert:user:config:tolerancetables#Invoke]]\\ 
 • [[en:infra-convert:user:config:tolerancetables#“Length measurements” group]]\\ 
 • [[en:infra-convert:user:config:tolerancetables#“Angular measurements” group]]\\ 
 • [[en:infra-convert:user:config:tolerancetables#“Radius of curvature and chamfers” group]]\\ 
 • [[en:infra-convert:user:config:tolerancetables#Save/Export]]

\\ 

</WRAP>
</WRAP> </WRAP>

==== Invoke ====

The menu can be invoked as follows:

<WRAP group>

<WRAP column 20%>
**Menu bar**
</WRAP>

<WRAP column 75%>

Click on **Edit** and then on **Project settings** in the drop-down menu that opens. The //Project settings// menu window opens. Select the **Tolerance tables** tab in the list on the left side of the window.

</WRAP>
</WRAP>

\\ 

==== “Length measurements” group ====

{{page>en:infra-convert:user:config:tolerancetables:linear_en}}

\\ 

==== “Angular measurements” group ====

{{page>en:infra-convert:user:config:tolerancetables:angle_en}}

\\ 

==== “Radius of curvature and chamfers” group ====

{{page>en:infra-convert:user:config:tolerancetables:edge_en}}

\\ 

==== Save/Export ====

{{page>en:infra-convert:user:config:save_project_settings}}

{{page>en:infra-convert:user:config:backup_project_settings}}

<WRAP noprint>

----

<WRAP group>
<WRAP col2>

<WRAP rightalign>
**Go to previous page**\\ 
Settings > Settings > [[en:infra-convert:user:config:administration|Administration]]
</WRAP>

**Go to next page**\\ 
Settings > Project settings > [[en:infra-convert:user:config:label|Tags]]

</WRAP> </WRAP>

</WRAP>