Table of Contents
infra - DAT Transmitter
This page contains information about the infra - DAT Transmitter.
The infra - DAT systems transmitters can be connected to any of the usual digital measuring devices. As different measuring device manufacturers use different connectors, each transmitter is shipped with the appropriate connector for your device(s). Visit our shop for an overview of the available connectors.
Using high performance radio technology, the tried and tested infra - DAT system has an impressive transmission range in the industrial environment. The infra – DAT transmitters come as two variants (Type A and Type C), based on different battery capacities.
Since every transmitter has a unique ID number, measuring equipment can easily be monitored and the transmitted data tracked. LEDs on the transmitter tell the user when data is transmitted.
It is possible to connect any number of digital measuring devices to a measurement station. A total of 68 available frequency channels means that up to 68 measuring sites can be independently serviced without any mutual interference. The Measuring Data Manager software (MDM -Tool) provides quick and easy organization of measuring device to measuring site.
Depending on application and local conditions data can be radio transmitted up to a range of 100 metres.
To transmit data to a PC you need a infra - DAT receiver and our Measurement Data Manager software shipped with the receiver. You can also download this software from the following link on our website:
http://www.elias-gmbh.de/de/produkte/infra-dat/support/treiber.html
Read the contents of this very carefully. Failure to follow its instructions may invalidate guarantees!
Intended use
This device may only be used as authorized and compliant with all the information published about its use. Any use or application other than that expressly authorized is deemed inappropriate. The manufacturer accepts no liability for any damage arising from such misuse. Comply with and observe all laws and regulations applicable for use of the device.
Installing the batteries
Transmitter typ A
To insert the batteries, open the battery compartment. Insert the batteries making sure polarity is correctly aligned. Replace the battery compartment lid.
Transmitter typ C
To insert the batteries, unscrew and remove lid. Insert the batteries making sure polarity is correctly aligned. Replace the lid and tighten the retaining screws.
Technical data
Technical data for Type A transmitter
| Radio transmitter frequencies | 433.05MHz - 434.79MHz |
| Frequency channels e | 69 |
| Transmitter batteries (housing type A) | 1 x CR 1/3 N (3V) |
| Operational temperature range | +10°C … +35°C |
| Relative humidity | 30% - 90% (non-condensing) |
| Appliance class | IP40 |
| Transmission range (depending on local conditions) | up to 100m |
| Dimensions L x W x H | 52mm x 26mm x 16mm |
| Type | RCS-433-A |
| Order number | ID001….. |
Technical data for Type C transmitter
| Radio transmitter frequencies | 433.05MHz - 434.79MHz |
| Frequency channels | 69 |
| Transmitter batteries (housing type C) | 1 x CR 123 A (3V) |
| Operational temperature range | +10°C … +35°C |
| Relative humidity | 30% - 90% (non-condensing) |
| Appliance class | IP40 |
| Transmission range (depending on local conditions) | up to 100m |
| Dimensions L x W x H | 62mm x 42mm x 22mm |
| Type | RCS-433-C |
| Order number | ID002….., ID006….. |
Declaration of Conformity: http://www.ELIAS-GmbH.de/doc/infra-DAT.pdf
