ELIAS GmbH
Produktdokumentationen

This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong.

~~NOTOC~~

<WRAP noprint>

> User manual #@IC_HTML@# > Settings > Project settings

</WRAP>

====== Tolerance tables ======

----

The general tolerance tables valid for the project can be selected on the //Tolerance tables// tab of the //Project settings// menu. Click on

  * **Apply,** at the bottom of the window to save the changes without closing the window,

  * on **OK,** to save the changes and close the window or

  * on **Cancel,** to discard the changes.
 
The settings are saved with the project.

> **Note** Your CAQ system provider or administrator may be able to prevent you from changing some settings under certain circumstances. Please contact them if an incorrectly set option interrupts your workflow.

<WRAP noprint>
<WRAP group>
<WRAP column 35%>
//**__Content__**//

 • [[en:infra-convert:user:config:tolerancetables#Invoke]]\\ 
 • [[en:infra-convert:user:config:tolerancetables#“Length measurements” group]]\\ 
 • [[en:infra-convert:user:config:tolerancetables#“Angular measurements” group]]\\ 
 • [[en:infra-convert:user:config:tolerancetables#“Radius of curvature and chamfers” group]]

\\ 

</WRAP>
</WRAP> </WRAP>

==== Invoke ====

The menu can be invoked as follows:

<WRAP group>

<WRAP column 20%>
**Menu bar**
</WRAP>

<WRAP column 75%>

Click on **Edit** and then on **Project settings** in the drop-down menu that opens. The //Project settings// menu window opens. Select the **Tolerance tables** tab in the list on the left side of the window.

</WRAP>
</WRAP>

\\ 

==== “Length measurements” group ====

{{page>en:infra-convert:user:config:tolerancetables:linear_en}}

\\ 

==== “Angular measurements” group ====

{{page>en:infra-convert:user:config:tolerancetables:angle_en}}

\\ 

==== “Radius of curvature and chamfers” group ====

{{page>en:infra-convert:user:config:tolerancetables:edge_en}}

\\ 

<WRAP noprint>

----

<WRAP group>
<WRAP col2>

<WRAP rightalign>
**Go to previous page**\\ 
Settings > Settings > [[en:infra-convert:user:config:export|Export]]
</WRAP>

**Go to next page**\\ 
Settings > Project settings > [[en:infra-convert:user:config:label|Labels]]

</WRAP> </WRAP>

</WRAP>

ELIAS GmbHProduktdokumentationen

User Tools

Site Tools

Page Tools

ELIAS GmbH
Produktdokumentationen