ELIAS GmbH
Produktdokumentationen

This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong.
===== Steinwald Input =====

The additional module is not included in the basic version of the MDM-Tool.

==== Configuration of a Steinwald-Interface-Box ====

The following describes how to configure a Steinwald Interface Box as an input device.

{{:en:mdm:inputdevices:steinwald_eng_a1.png?500|}}

To configure the interface box select it with a single mouse click from the list.

{{:en:mdm:inputdevices:steinwald_eng_a2.png?500|}}

Click the **Configure** button below the list to open the configuration window. Alternatively you can open the context menu via a right mouse click and select the **Configure** menu entry.

{{:en:mdm:inputdevices:steinwald_eng_a3.png?500|}}

In the Configuration menu you can activate or deactivate the interface box by clicking the **Enabled ** check box.

The **COM port name** drop down menu shows all active COM ports. Select the port that the interface box should connect to. If the listed COM ports are not up to date, click the **Refresh** button to update the list.

In the **Baud rate** drop down menu you select the baud rate of the box.

Click **Apply** to accept the settings you have made. Click **OK** to save the settings and close the Settings window. Clicking **Cancel** closes the window without saving any changes. 

After accepting your configurations, a corresponding number of measurement device channels is added to the list of input devices.



{{:en:mdm:inputdevices:steinwald_eng_a4.png?500|}}


\\
<WRAP pagebreak></WRAP>

==== Configuration of a measurement device ====

This section describes how to configure a measurement device channel of a Steinwald interface box.

{{:en:mdm:inputdevices:steinwald_eng_b1.png?500|}}

Click on the receiver you want to configure from the list.

{{:en:mdm:inputdevices:steinwald_eng_b2.png?500|}}

Click the Configure button below the list of devices to open the configuration window. You can also right mouse click to open the context menu and click on the Configure.

{{:en:mdm:inputdevices:steinwald_eng_b3.png?500|}}

In the Configuration menu you can activate or deactivate the measurement device by selecting or deselecting the **Activate** check box.

You can enter a name for the transmitter in the **Name** field. This is then displayed in the list. This makes identification easier if there are more than one device in the list. 

The serial number and type of transmitter is also displayed. These settings cannot be changed.

{{:en:mdm:inputdevices:steinwald_eng_b4.png?500|}}

In the **Feedback** menu select the output device from which you expect acknowledgement of receipt for measurement data. If you select the **Green LED** from the list, this LED on the transmitter will light up when a measurement value has been processed. Selecting **Virtual COM Port** or **Virtual Keyboard** from the list results in this device taking on the acknowledgement of receipt and the corresponding LEDs light up.

Click **Apply** to adopt the settings you have chosen. Clicking **OK** saves the data and closes the Settings window. Clicking **Cancel** closes the window without saving any changes.
ELIAS GmbHProduktdokumentationen

User Tools

Site Tools

Page Tools

ELIAS GmbH
Produktdokumentationen
