ELIAS GmbH
Produktdokumentationen

This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong.
====== Steinwald ======

The additional module for Steinwald interface boxes is not included in the basic version of MDM-Tool.

===== Configuration of a Steinwald Interface Box =====

The following describes how to configure a Steinwald interface box as an input device.

{{:en:mdm:inputdevices:steinwald_eng_a1.png?500|}}

To configure the interface box select it with a single mouse click from the list.

{{:en:mdm:inputdevices:steinwald_eng_a2.png?500|}}

Click the **Configure** button below the list to open the configuration window. Alternatively you can open the context menu via a right mouse click and select the **Configure** menu entry.

{{:en:mdm:inputdevices:steinwald_eng_a3.png?500|}}

In the Configuration menu you can activate or deactivate the interface box by clicking the **Enabled ** check box.

The **COM port name** drop down menu shows all active COM ports. Select the port that the interface box should connect to. If the listed COM ports are not up to date, click the **Refresh** button to update the list.

In the **Baud rate** drop down menu you select the baud rate of the box.

Click **Apply** to accept the settings you have made. Click **OK** to save the settings and close the Settings window. Clicking **Cancel** closes the window without saving any changes. 


{{:en:mdm:inputdevices:steinwald_eng_a4.png?500|}}


\\
<WRAP pagebreak></WRAP>

===== Configuration of a Steinwald measurement device =====

This section describes how to configure a measurement device of a Steinwald interface box.

{{:en:mdm:inputdevices:steinwald_eng_b1.png?500|}}

To configure the measurement device select it with a single mouse click from the list.

{{:en:mdm:inputdevices:steinwald_eng_b2.png?500|}}

Click the **Configure** button below the list of devices to open the configuration window. You can also right mouse click to open the context menu and click on **Configure**.

{{:en:mdm:inputdevices:steinwald_eng_b3.png?500|}}

In the configuration menu you can activate or deactivate the measurement device by selecting or deselecting the **Enable** check box.

You can enter a name for the devicein the **Name** field. This is then displayed in the list. This makes identification easier if there are more than one device in the list. 

The device's **Serial number** and **Type** are also displayed. These settings cannot be changed.

{{:en:mdm:inputdevices:steinwald_eng_b4.png?500|}}

In the **Feedback** menu select the output device from which you expect acknowledgement of receipt for measurement data. If you select the **Green LED** from the list, this LED on the transmitter will light up when a measurement value has been processed. Selecting **Virtual COM Port** or **Virtual Keyboard** from the list results in this device taking on the acknowledgement of receipt and the corresponding LEDs light up.

Click **Apply** to adopt the settings you have chosen. Clicking **OK** saves the data and closes the Settings window. Clicking **Cancel** closes the window without saving any changes.
ELIAS GmbHProduktdokumentationen

User Tools

Site Tools

Page Tools

ELIAS GmbH
Produktdokumentationen
